BMW Garage | BMW Meets | Register | Today's Posts | Search |
01-02-2021, 04:07 PM | #2 |
e91Owner
425
Rep 1,129
Posts |
|
Appreciate
0
|
01-03-2021, 08:28 AM | #3 |
Registered
0
Rep 4
Posts |
shall I understand that the probe + of digital meter goes to pin1 ( U_HR) and the negative probe goes to T_MRV wire?
and this will measure the resistance of control valve |
Appreciate
0
|
01-03-2021, 08:17 PM | #4 |
e91Owner
425
Rep 1,129
Posts |
|
Appreciate
0
|
01-04-2021, 12:08 AM | #5 |
Registered
0
Rep 4
Posts |
thanks for assistance
I think I found were the problem comes from, the resistance of this valve is around 4 MOhm that is far more then the value specified by ISTA diagnostic , range between 2.9 - 3.9 Ohm |
Appreciate
0
|
01-07-2021, 02:45 PM | #6 |
e91Owner
425
Rep 1,129
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|