[Mr. 5]

Unbelievable service and superb prices.
Pat, you get an A+ in my book.
Thank you very much for the perfect fitment and perfect paint match.

For those of you that don't know, I started this thread regarding the splitters that I purchased from Bavdom that turned yellow.

http://www.e90post.com/forums/showthread.php?t=101075

It was going to cost me $250 to get the splitters repainted or I could go with M Force Design splitters for $200. Well, it was a no brainer. But I was wondering what they would look like because when I received Bavdom's splitters there was a lot of work to make them fit. I actually had to use betalink to glue them so there wouldn't be any gaps.

It was completely different with the M Force Design splitters. No glue and I didn't even have to use the tape the fitment was so good.
The quality is 100% and the fitment is perfect!
Their product is also lighter than Bavdom's since they are fiberglass instead of plastic.

Thank you very much Pat!

[koreez88]

M Force pwns BavDom anyday

[Inspired]

planning to buy them but could you tell the difference from the authentic one and this one? LMK thx

[Mr. 5]

Originally Posted by twinturbo335

planning to buy them but could you tell the difference from the authentic one and this one? LMK thx

I don't know what you mean about authentic and this one, but I'll tell you the difference between Bavdom's and these.

Bavdom's product was thick and hard to work with.
I believe Carking's is actually thicker than Bavdom's splitters.
M Force Design's splitters are very light, thin, and very easy to work with. The thicker these splitters are, the easier it is to notice the lines of where they end at the bumper.
I used 3M tape just for piece of mind but I seriously didn't even need it.

[Inspired]

there is actually a gap. is it suppose to be like that?

well what i meant if you can tell by the real authentic one is if you can tell the difference between the OEM one that BMW dealers sell and the one M force sells which is OEM type

[Mr. 5]

Originally Posted by twinturbo335

there is actually a gap. is it suppose to be like that?

well what i meant if you can tell by the real authentic one is if you can tell the difference between the OEM one that BMW dealers sell and the one M force sells which is OEM type

The reason why there is any gap is because i chose to use double sided tape all around. If I didn't use the tape then it would be absolutely flush with the bumper.

I'm telling you guys that this product is unbelievable, and after trying the other splitters, these are by far the best.

[FotiosF90M5]

Ive spent so much money on carkings and they still suck.I might have to buy these and be done with it. thanks for the heads up Mr.5.

[M-Force_Design]

thanks for the kind review. we will continue to do our best to serve this community

[scooby9]

I can see how the appearance could be further enhanced by not using tape. What is the recommended method for attaching the splitters? Betalink?

Thanks.