![]() |
![]() |
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
11-25-2024, 11:04 AM | #1 |
Registered
0
Rep 1
Posts |
BSD Issue - Possible Water pump?
Hi all,
I recently started having an issue with the BSD line and wanted to see your thoughts. The car is a 2010 E60 535i. Couple of days ago I went to check my oil level in i-drive and noticed that it said that the oil level reading is inactive. So I started looking into the issue. Went through the BSD troubleshooting by unplugging each BSD component one by one - IBS, Alternator, Oil level sensor and waterpump. When I unplugged the waterpump, cleared the codes, the code did not appear again. I plugged the waterpump back in and everything was working normal. The oil level was active again and the waterpump did not run constantly. So I figured it must've been a bad connection at the waterpump. A day later the issue came back. Is it possible that the waterpump electronics are on their way out? Like I said, when I disconnected the waterpump and plugged it back in it was all good. I'll go under again today to clean the plug really good and see if that helps. Thank you. |
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|