BMW E60 5-Series Forum |  
BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read  

Go Back   BMW E60 5-Series Forum | > BMW 5-Series (E60) Forums (2004 - 2009) > General 5-series and M5 (E60) Forum

Post Reply
Thread Tools Search this Thread
      11-29-2022, 02:10 PM   #1
Enlisted Member

Drives: 2010 BMW 535XI
Join Date: Jun 2018

iTrader: (0)

idrive has bmw logo, then goes black, then resets

Just bought a used ccc unit for my 07 M6 because the original one was draining my battery. Using winkfp, i programmed the modules in the correct order and it was working great. I own a k+dcan cable from bimmergeeks and it has a toggle on it that has 3 positions which I assume is used for older cars and such. I always keep it all the way to the right. Anyways, fast forward a couple days. I connect it to my car and open up ista. I then click start vehicle test and it takes a lot longer than usual. I then notice my idrive screen goes to the bmw logo and then black screen and then resets and keep doing that over and over again. I am confused why its doing this after connecting it and running ista. I later find out that my k+dcan toggle is slid all the way to the left. Not sure how that happened but that doesnt matter. At this point I cant seem to get my idrive back to normal and i even tried flashing all the modules again but now they keep failing. I go to inpa >UIF to see the list of modules and notice CCC isnt even listed anymore. Did i fry my CCC? Should I buy another one or is it still savable? Thanks.
Appreciate 0
Post Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 03:25 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2023, vBulletin Solutions Inc.,,,,,,,,, logo and trademark are properties of BIMMERPOST