View Single Post
      07-17-2016, 08:44 AM   #8
larryn
Lieutenant General
United_States
2146
Rep
10,176
Posts

Drives: '97 332ti, '21 X5 45e, '16 GT4
Join Date: May 2005
Location: Seattle

iTrader: (2)

Sounds like it could be an air/fuel ratio issue, and therefore a carburetor issue. It could be that air is being introduced through a bad seal, o-ring or gasket... Or you are flooding or starving gas due to needles being shot, o-rings messed up or gumming up elsewhere. Since you already took apart the float sand noted gunk, I assume it's not that new, but you are comfortable doing things like that.

Carburators are finicky and if you prefer to take care of it yourself, I would just suggest getting a carburetor rebuild kit from the manufacturer. Otherwise, most small engine repair places do pick-up and drop-off service.
Appreciate 1