[attila]

Today was my first track session with the BFG Gforce R1 tires and DSC turned completely off. Someone mentioned on this forum that the MDM mode on track may contribute to break wear and overheating, so I turned it off.
Well, it turned out I am not such a good driver and spinned the car twice (once the engine light came on, and had to go to the pit in limp mode). After that I was so afraid that my lap times were really behind the MDM laptimes. I could feel the limits of adhesion better with the PS2 tires. Or just my BFG tires are not set correctly. I am running at 41-42 PSI (front rear) hot.
The XP-10 holding up well, this was their sec. session. Still have almost half of the pad.

So what is your track DSC and EDC setting, and why did you choose the one you are using??