|
Did you solve this problem? If you swapped the driver side headlight onto the passenger side headlight and that did not work, it might be an issue with your footwell module...See if you can read your fault codes from that.
If you can't read your footwell module fault codes test the voltages from the headlight harness.
Pin #1 is for Angel eyes
#2 is ground for the bixenon
#3 is the bixenon low beam
#4 is ground
#5 is the bixenon shutter
#6 .. 11 are for the levelling control but you said those are working
#12 is the indicator
So i would be checking that you are getting voltage from pin #3, and pin #2 is making good ground contact (check this by measuring the resistance - it should be 0 ohms)
|